Omnibus F4 Nano V6 飞控

Omnibus F4 Nano V6飞控
厂商: Airbot
编号: AB80100 (淘宝链接: AB80100) (优品链接: AB80100)

产品概述:
5x UARTs
通过四合一接口支持电调遥测功能
5V/2A BEC输出
支持2-6S锂电
固件请使用V2版驱动, 设置CLI, set gyro_to_use = SECOND
该新款V6版无刷AIO飞控体积更小，同时兼有众多特点，比如终端兼容F1处理器, F3 become the bottom wrung, but don't worry, this little board features an F4 MCU.
Its Betaflight OSD is connected over SPI in DMA, and is designed on the current proposed architecture for betaflight.
It will show you any and all data you want on your FPV feed and you can change settings including tune your PIDs without taking your goggles off!
The board also features an MPU6000 gyro connected over SPI for fast, accurate, low noise gyro data and can support 2-6s direct input.

请注意:
如果想使用该飞控配合同品牌四叶一电调，仅需另购8针排线(选购件/不含)


产品特点:
01. 2-6s direct input (adaptor to connect to Wave 4in1 ESC providing power and ESC signal connection (note Wave is 2-4s)
02. MPU6000 gyro connected by SPI for low noise, clean, high frequency gyro samples
03. BMP280 Barrometer to enable altitude hold
04. Betaflight OSD
05. Onboard voltage sensor
06. On board 5v regulator, components rated to 2A - recomended 1A max to prevent heat build up)
07. Built in L-C filter to provide clean power to FPV kit
08. STM32 F405 MCU running betaflight 3.2
09. pin headers for SBUS/PPM input
10. output for 4 motors on JST-SH 1.0 8pin plug connects to Airbot Wave 4in1 ESC (The Option 8pin 4in1 Cable)
11. Size 25x25mm (20x20mm M3 mount holes)


包装内容:
1x Omnibus F4 Nano V6飞控